[genivi-dlt] Switch off Log and File transfer

Lipka, Christoph (ADITG/ESA) clipka at de.adit-jv.com
Wed Aug 2 02:32:52 EDT 2017


Hi Prathap,

When using dlt-control, are you running DLT Viewer as well? If so, make sure you unchecked "Send Default Log Level ..." in the "ECU" tab and "auto-reconnect" in the "IP" tab of the ECU Configuration dialog.

Best regards

Christoph Lipka
Engineering System & Architecture (ADITG/ESA)

Tel. +49 5121 49 6945


-----Ursprüngliche Nachricht-----
Von: genivi-diagnostic-log-and-trace [mailto:genivi-diagnostic-log-and-trace-bounces at lists.genivi.org] Im Auftrag von Prathap Chandran
Gesendet: Mittwoch, 2. August 2017 08:24
An: genivi-diagnostic-log-and-trace at lists.genivi.org
Betreff: [genivi-dlt] Switch off Log and File transfer

Hi All,

I am actually doing a feasibility of using dlt-daemon for my project. I have compiled and run the project successfully and log transfer is working fine and now the logs and transferred files can view using dlt-viewer.

One of the main requirement of my project is to completely switch off the log transfer and file transfer behaviour via dlt-daemon using some control signals. When I search for it, found only one option for it using the dlt-control SW component of DLT.

dlt-control -l 0 -a LOG -c TEST 192.168.3.38

But even after the above operation, when sending messages using the example tool dlt-example-user, the logs are still transferring.

So could you please suggest a solution for completely switch off the logs and file transfer without stopping dlt-daemon?

Thanks & regards
Prathap
_______________________________________________
genivi-diagnostic-log-and-trace mailing list genivi-diagnostic-log-and-trace at lists.genivi.org
https://lists.genivi.org/mailman/listinfo/genivi-diagnostic-log-and-trace


More information about the genivi-diagnostic-log-and-trace mailing list